h5-20 on new bp70 m series

[fireater]

i have a bp70m45 that like to throw h5-20's. every few months. i updated fw. replace fuser did meandering 6-8 "many times". still doing it. i think the fixing sleeve dont turn when its waking up causing the error but i dont see any bulletins or info on this issue. any thoughts?

[JLSam]

It's a shame no one has responded.

About to go to service call for this error code, only 2k pages, and 6 months in field. We will see. :|

Also, there was originally an L4-03 error, then after reboot H5-20.

We will see.

[ihatefinishers13]

It's a shame no one has responded.

About to go to service call for this error code, only 2k pages, and 6 months in field. We will see. :|

Also, there was originally an L4-03 error, then after reboot H5-20.

We will see.

I haven't had any issues with this code yet. All I know is, I'd much rather have the 71 series' fuser back because these things are (pun intended) hot garbage.

[Hart]

Only 45 minutes to change the fusing belt, it's fineeeee

[Smeden]

New fuser. it's a worldwide problem. The pressure on the pressroll is to high, due the low fixing temp. Sharp has no solution yet.

[fireater]

we are beginning to think is power issue