[Error Code] L4-08 MXM1100 - Waste toner transport pipe lock

[rayjeek]

I have MXM1100 here with L4-08 (Waste toner transport pipe lock). I have not attended yet but just wandering if someone had had this fault code before.

[OMD-227]

I have once before. Silly twat left the cap on the waste toner bottle. Obviously blocked the whole pipe up as it had nowhere to go. You'll need the vac as it will be messy. Luckily, mine came up OK. Run the waste toner motor sim to get it flowing again and to confirm that toner is flowing into the container.

[rayjeek]

I have once before. Silly twat left the cap on the waste toner bottle. Obviously blocked the whole pipe up as it had nowhere to go. You'll need the vac as it will be messy. Luckily, mine came up OK. Run the waste toner motor sim to get it flowing again and to confirm that toner is flowing into the container.

In my case the pipe was just choked with granules of toner, vacuumed same and run motor DM in sim tested ok.

[OMD-227]

What sort of environment is the machine in? It would have to be very hot & humid room for the waste toner to block up. Check sim 44-14 for your room temp & humidity sensor output. If its above maximum specified in S.M. you might get this one again.

[rayjeek]

I will definitely check the room temperature on next visit./ Thanks