AR-M450n, developer issue

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • DINGO
    Senior Tech

    500+ Posts
    • Nov 2007
    • 661
    #1

    AR-M450n, developer issue

    Good night
    I have a problem, with a ar-m450, that is the developer value low very quickly, and beguins give me EL-EE, when i try run sm 25.

    I already replace, developer unit, and the developer, for three times, and the problem continues.

    summarizing, when install a new developer, the SM 25-2 fixed in 125, 15/20k copys
    stay in 70 for exemple.

    appreciate any suggestions...
    Tags: ar-m450n, developer, developer unit, development unit, good, install, issu, issue, low, m450, replace, unit
    • ptrflrs
      Glorified Parts Swapper

      100+ Posts
      • Dec 2010
      • 192
      #2
      are u sure u r using right developer? i think any value under 100 on 25-2 on this model is trouble. i think there is a bulletin for this, u might have to replace the development unit and check the firmware on it.
      jesus loves you! (everyone else thinks you're an assh*le)
      street cred: CompTIA A+ & Network+ Certified; Konica Minolta Gold Seal x2,
      Konica Minolta Outward ASSociate, Ricoh, Sharp, Lexmark trained

        Comment

        • CBMWilson
          Technician

          50+ Posts
          • Sep 2010
          • 53
          #3
          Yes, make sure you're using the AR450ND developer for North America, AR450DV for EU. Check your local settings.

            Comment

            • DINGO
              Senior Tech

              500+ Posts
              • Nov 2007
              • 661
              #4
              Yes,

              I`m using the right dv, 450dv, and i have a lot of ar-m450n and are working with the same
              dv.

              thanks

                Comment

                • blackcat4866
                  Master Of The Obvious

                  Site Contributor
                  10,000+ Posts
                  • Jul 2007
                  • 22996
                  #5
                  Is the developer agitating? A drive issue could cause this problem. Have you pinned out the wiring harness between the developing unit and the PCU? Very rare, but maybe a PCU PWB. =^..^=
                  If you'd like a serious answer to your request:
                  1) demonstrate that you've read the manual
                  2) demonstrate that you made some attempt to fix it.
                  3) if you're going to ask about jams include the jam code.
                  4) if you're going to ask about an error code include the error code.
                  5) You are the person onsite. Only you can make observations.

                  blackcat: Master Of The Obvious =^..^=

                    Comment

                    • DINGO
                      Senior Tech

                      500+ Posts
                      • Nov 2007
                      • 661
                      #6
                      ok

                      I'll check these prominors, thanks

                        Comment

                        Previous template Next
                        Working...