sharp ar m257

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • poco
    Junior Member
    • Sep 2007
    • 7
    #1

    sharp ar m257

    I am pming mach with 191k on it it has never been serviced do i have to reset any counters for copy quality and is trere asim for dev replacement? thanks for any help
    Tags: copy, copy quality, counters, help, m25, quality, replacement, reset, sharp
    • johnbla
      Technician

      50+ Posts
      • Apr 2005
      • 94
      #2
      Re: sharp ar m257

      Check PM's
      regards

      John
      sigpic
      " The Game never ends..When your whole World depends..On the Turn of a Friendly Card..."

        Comment

        • Dark Helmet
          Senior Tech

          Site Contributor
          500+ Posts
          • May 2009
          • 835
          #3
          Re: sharp ar m257

          Paul this man needs a manual!

          191k and it's never been touched? The copies must be crap. Drum, DV, blade, charger and probably a fuser (at least clean the felt on the back side of the heat roller). Make sure you take a Q-TIP and clean the TCS sensor off under the mag roller.

          Sim 24 resets your M-counter, drum & DV.
          Once all counters are reset and new DV installed turn machine on with front door open, enter sim 25-2(DV Calibration), close the door and run the sim. Do not power the machine on with doors closed until the DV is calibrated.
          Evil will always triumph because good is dumb.

            Comment

            • JustManuals
              Field Supervisor

              5,000+ Posts
              • Jan 2006
              • 9838
              #4
              Re: sharp ar m257

              This Parts & Service manual can be purchased for $12.77 and downloaded immediately after payment from
              http://www.justmanuals.com


              Paul@justmanuals.com

                Comment

                Previous template Next
                Working...