TB-495R2

[DavePo]

Re: TB-495R2

Yeah we had six to update and even before the update had not had a belt problem. Though I did see a few where the belt was off center a bit, but not to the point of tearing.

[mojorolla]

Re: TB-495R2

Your dealership should have been sent the modified fulcrum for each machine it bought manufactured before Apr 2011. The p/n on the package is M-05-02-0-1-08, and yes it is much easier to replace the fulcrum rather the plate . Two of our machines that I installed the modified fulcrum and centered the belt at setup ripped within 10,000 copies/prints.

Well that is not good to hear! We have 4 of these in the field and since the mod have not had any problems. The pin is so simple to replace, an end user could do it. Zoo, I will keep my fingers crossed.

[ZOOTECH]

Re: TB-495R2

hello guys, i just recently had a MX2610N fuser belt damaged on one of my clients photocopier,however i am abit confused by the bulletin TB-495R2, the heat roller frame is NOT modified and the heat frame fulcrum plate is NOT modified, my question is what modified part should i change at this point? the fulcrum plate or heat roller frame, i know that i need to get the belt replaced etc. but not sure about which mod to do, thanks in adavnce

Your dealership should have been sent the modified fulcrum for each machine it bought manufactured before Apr 2011. The p/n on the package is M-05-02-0-1-08, and yes it is much easier to replace the fulcrum rather the plate . Two of our machines that I installed the modified fulcrum and centered the belt at setup ripped within 10,000 copies/prints.

[DavePo]

Re: TB-495R2

Replace the fulcrum it is a hell of a lot easier than the frame.

[redserv]

hello guys, i just recently had a MX2610N fuser belt damaged on one of my clients photocopier,however i am abit confused by the bulletin TB-495R2, the heat roller frame is NOT modified and the heat frame fulcrum plate is NOT modified, my question is what modified part should i change at this point? the fulcrum plate or heat roller frame, i know that i need to get the belt replaced etc. but not sure about which mod to do, thanks in adavnce