Sharp AR-C160 Random Red line

Collapse
X
Collapse
+ More Options
Posts
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • lilhyperbratsmom
    #1

    Sharp AR-C160 Random Red line

    I'm new to my machine. I'm getting a faint random red line on all printed pieces. Help please
    Tags: arc160, beast, cleaning blade, developer unit, grid, help please, line, off, random, red, sharp, sharp ar
    • bilyahn
      Service Manager

      1,000+ Posts
      • Dec 2006
      • 1470
      #2
      Is the line from top to bottom? If so then it is the cleaning blade that is causing the problem. Normally I just clean it off and the problem goes away for awhile. Also check the toner seal.

      Good luck.

        Comment

        • Jaws
          Trusted Tech

          100+ Posts
          • Oct 2007
          • 235
          #3
          Drum Drive Gear

          Could be a broken drum drive gear. Machine is bad about breaking all of them.

            Comment

            • wtroll
              Technician

              50+ Posts
              • May 2008
              • 85
              #4
              Hi,
              you can try to exchange Magent primary charger with Cyan one.
              Now if you have a Cyan line, clean the primary charger and grid.

              Luca

                Comment

                • mtech
                  Technician

                  250+ Posts
                  • Mar 2007
                  • 307
                  #5
                  Is the firmware updated and is the developer unit an "N" version? You may need to replace the developer unit and developer. This was a common issue with this beast.

                    Comment

                    Previous template Next
                    Working...