Sharp MX-4501N

[tcypy1961]

Is this Sharp MX-4501N known to always go into "adjusting print quality" or is there something wrong with the copier? Thank you for any help given.

[drowranger]

Re: Sharp MX-4501N

Check if the fuser heater lamps are working correctly on sim 5-2. can be fuser related.

[ntbann]

Re: Sharp MX-4501N

Also do a full calibration. Clearing all the half tones and also make sure to run 44-2 and 44-13.

[spanky]

Re: Sharp MX-4501N

See attached bulletin

[walterman]

Re: Sharp MX-4501N

Spanky. beat me to it. Those box's have done that since day one believe me, every customer has complained about it. I tried making the above changes for a couple of customers, then I ran into color consistency issues, so I set them back to the factory settings. Also, The MX-4501 color is also compromised by cheap paper make sure your customer uses quality paper when making clicks.

[tmaged]

Re: Sharp MX-4501N

More than likely the DV is oxidized & needs to be replaced. Even though the CQ may not look bad, process control isn't seeing what it needs.
Subsequently it calibrates frequently.