Toshiba e-232 ADD PAPER n both trays Elevator is OK,

[rapidocument]

Toshiba e-232 ADD PAPER n both trays Elevator is OK, updated firmware but no luck so far, exchanged actuators and sensors from working machine, still the same, elevator unit was tested with a working one, fuses in the LVPS are tested OK.
running out of ideas, by the way the copier makes good copies from the bypass (only)

[rapidocument]

Re: Toshiba e-232 ADD PAPER n both trays Elevator is OK,

and both trays won't lift up (additional info).

[blackcat4866]

Re: Toshiba e-232 ADD PAPER n both trays Elevator is OK,

Test every sensor in 03 Mode.

You may have a vertical path clutch problem. the sheet bypass doesn't use that clutch. These clutches cannot be disassembled, but you can work alcohol into them, and get it turning more freely. =^..^=

[riyadh hossainbd]

Re: Toshiba e-232 ADD PAPER n both trays Elevator is OK,

Toshiba e-232 ADD PAPER n both trays Elevator is OK, updated firmware but no luck so far, exchanged actuators and sensors from working machine, still the same, elevator unit was tested with a working one, fuses in the LVPS are tested OK.
running out of ideas, by the way the copier makes good copies from the bypass (only)

Change lgc board and drawer entrance sensor or check cable

[rapidocument]

Re: Toshiba e-232 ADD PAPER n both trays Elevator is OK,

Cable tie too tight broked wire/ (inner damaged), bad wiring from PCB to Elevator was the culprit

Thanks to evereybody, specially to Hossain and BlackCat.

Machine is up+running now.

[blackcat4866]

Re: Toshiba e-232 ADD PAPER n both trays Elevator is OK,

Congratulations on your success. =^..^=