Please help on this, my e-studio 206 not booting after replacing cmos battery. No display on panel. After 0+8+ power, display for few second then goes disaper with beep. Thanks in advance
-
-
Re: E-studio 206 not booting after replacing cmos battery
Exactly what did you hope to achieve by removing the battery? Clearing the counts to zero?
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: E-studio 206 not booting after replacing cmos battery
Actualy machine was not in use since last 8 month. Battery get rusty and disccharged. i use method as given below. machine is on now. but now scanner get stucked while making copy. and gives to much noice in gears seems ike belt slip. please help.Re: toshiba e-studio 206factory initialize, and 0-5,0-8 initialize.
- 1+3+*+power on
- 0-8 +power on 388
- 0-8+ power on 655
- 1+3+#+power on
- 0-2 + power on 44 and start button
if not replace the S-RAM
Comment
Comment