Toshiba 4520c freezing when printing

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • jamesyboy
    replied
    Re: Toshiba 4520c freezing when printing

    power supply

    Leave a comment:


  • Blizzoo
    replied
    Re: Toshiba 4520c freezing when printing

    Check the fuser pressure springs if they run on release pressure mode

    Leave a comment:


  • Fattdaddy
    replied
    Re: Toshiba 4520c freezing when printing

    Checked for errors. Nothing shows except for some RADF misfeeds. Cleaned the thermopiles, a little dusty. I have seen that before but didn't lock the control panel. See how this goes. Also checked the fuser wiring - looks ok.

    Leave a comment:


  • blackcat4866
    replied
    Re: Toshiba 4520c freezing when printing

    Kinda similar: If the tech that rebuilt the fuser mis-routed the heat lamp wires, then re-installed the right cover pinching the wires to the frame, the machine will fall back into warmup in the middle of a print job, then idle for 10 minutes or so while it attempts to warm up, then it will resumes printing.
    =^..^=

    Leave a comment:


  • SalesServiceGuy
    replied
    Re: Toshiba 4520c freezing when printing

    Sounds like the thermistors have dust on them. Common issue. Search this forum for the answer.

    Leave a comment:


  • blackcat4866
    replied
    Re: Toshiba 4520c freezing when printing

    Are you sure there's no error code? Like CA00 or CE40? Did you print off the 9S-107 error/jam list? =^..^=

    Leave a comment:


  • Fattdaddy
    started a topic Toshiba 4520c freezing when printing

    Toshiba 4520c freezing when printing

    Cus says the machine will stop and control panel will freeze and they have to shut down the machine to clear. Have updated firmware and replaced HDD. Doesn't seem to have helped.
Working...