E-4525 w/MJ1048 & MJ6011

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • Rusty.Harris
    Senior Tech

    Site Contributor
    500+ Posts
    • Jan 2021
    • 605
    #1

    E-4525 w/MJ1048 & MJ6011

    Out of the box new setup. CC61 Checked a few things then took the hole punch out and didn't see anything until I
    looked at the connector on the MJ1048. Not sure a middle pin got bent, but it did. Straightened it and then had to
    pull it out a bit more a it was pushed down. (pass through connector)

    CC61_MJ1048_MJ6011.png
    Tags: None
      👍 3
    • Vincent128
      Trusted Tech

      Site Contributor
      250+ Posts
      • Sep 2015
      • 342
      #2
      Gremlins...
        👍 1

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22922
          #3
          Nice catch.
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            Previous template Next
            Working...