2508A DOC FEEDER

[bruce 49dcs]

I can buy a 2508a from wulff but it has a c550 dual scan if error. I have a parts machine with a regular radf can I install that and will it work or maybe an 08 code to tell the machine its a single scan radf

[SalesServiceGuy]

Re: 2508A DOC FEEDER

... assuming you have an MR3031 RADF, no problem. Update the firmware on all to match.

[bruce 49dcs]

Re: 2508A DOC FEEDER

... assuming you have an MR3031 RADF, no problem. Update the firmware on all to match.

yes I have the mr3031 but I dont have the firmware can you maybe help me with that please and thank you

[Rusty.Harris]

Re: 2508A DOC FEEDER

Probably need to also set 08-9995 to zero so the machine thinks there isn't a doc feeder, so it will automatically go out
and look for one, and make all the necessary changes between the DSDF & the RADF. Also, don't forget to remove the
board for side 2 from the system board.

[bruce 49dcs]

Re: 2508A DOC FEEDER

probably need to also set 08-9995 to zero so the machine thinks there isn't a doc feeder, so it will automatically go out
and look for one, and make all the necessary changes between the dsdf & the radf. Also, don't forget to remove the
board for side 2 from the system board.

good stuff you guys are great thanks much

[Blizzoo]

Re: 2508A DOC FEEDER

Install the RADF and go to 05 mode and do 05-3401, this code will set the default adjustment values for RADF wich differs from DSDF. You probably don't need firmware but will be great to have them on same level