Estudio 3511/4511

[Guest]

Hi all
I have 2 machines not working properly. The 4511 reports Power Failure even though it boots up fine.
The 3511 reports a service required but I have tried to get the error code by pressing clear and 8 together but nothing happens. Can anyone please advise

regards
Mick

[copytechman]

Press FC key 2x, to clear the power failure message (power was interupted to the machine without a proper shutdown) and on the other machine, c + 8 only works for jam codes and service call errors, what service is it asking for?

Regards!

A.

[banno]

Press FC key 2x, to clear the power failure message (power was interupted to the machine without a proper shutdown) and on the other machine, c + 8 only works for jam codes and service call errors, what service is it asking for?

Regards!

A.

Thanks.
I have just the service icon flashing and nothing else

regards
Mick

[emujo]

not sure what you mean by "icon is flashing". 08/253 will show you the last 30 or so service/jam error codes by date and configuration. What is the last "C" code you see here?

[banno]

Thanks for your help. The error code is F100. Is it serious

[emujo]

Only if you want to copy/scan/print or fax!!!! Bad HDD. You'll need to replace the HDD and re-load system firmware. I hope your next post is not "how do I do this, and can you send me the firmware?" If you don't know how this is accomplished, get a qualified Toshiba tech involved, probably will run you $150 for the HDD and 1 hour of labor. EMujo

[fourl6]

The 4511 reports Power Failure even though it boots up fine.

It says Power Failure when it isnt shutdown properly, to turn off a 3511 / 4511 press

1 User Functions
2 User (Tab)
3 Shutdown

not shutting down properly can wreck hard drives (like your other machine)

[gfady1]

Hi all

i have 2 problems with my toshiba 4511 and i need someone help

FIRST: when i open my toshiba i find language (svenska ) and i can't change it from the language menu as there is no other language .. and when i went to the settings 08-220 i can't change No. 5 language to any other language (when i change to No. 1 and restart the machince i find is changed automatically to No. 5 again)

SECOND: when i give a print order from the computer using any connection (USB , Parallel or Network) the data led keeps blinking but no printing is there and even when i go to job status i find no orders there,, and the copier can't do any thing till i restart it..

Noting that all process of coping is working super fine ..

Can any body help me Please ( i think it's a matter of firmware but i can't get it even throught toshiba agency)

Fady Gendy
Gfady1@hotmail.com