help for reset e-studio 25-35-45

[wtroll]

Hi,

It's a Toshiba known problem.
Black developer lift clutch was modified with a new type one.
Check and replace it, if necessary.

Regards

[etsmultan]

yes thts right u can do by this way

[denkhongduong]

yes thts right u can do by this way

Please tell me what exactly do I have to do to make the machine starts with new HDD installed?

[expresscopycenter]

studio45 c47 error

please help me. studio45 c47 error. tnx ahead

[wtroll]

Hi,
follow these instructions:

[C47] IH power voltage is abnormal/IH initialization error

1. Check the AC input voltage
Check if the AC input voltage is within the specified range.
(especially when the heater becomes ON after the power is turned ON (the copier is warming up))

2. Check the thermostat
Check if the thermostat is blown.

3. Check the IH control board
(1) Check if the AC input connector on the IH control board or the LGC I/F connector J522 is
disconnected?
(2) Check if the fuse on the IH control board has blown.
(3) Replace the IH control board.

4. Check the LGC board
(1) Check if the connector J317 is disconnected.
(2) Check if the conductor pattern on the board is short- or open-circuited.
(3) Replace the LGC board.

5. Clear the status counter

• The error occurred when the machine is in the ready state: "17"

Good luck!