[Misc] Toshiba Estudio 351C Copy and Print Quality

[jcontractor]

Hi,

Attached is a Scanned printout from a Toshiba Estudio 351C, It do the same in print and Copy. Second transfer roller was changed.
I'm doing some other cleaning procedures, but I think that will be like a standard cleaning. This failure could be another thing.

Any suggestions or comments will be really appreciated.

Thanks to all.

[tinnyjay]

Hi,

Attached is a Scanned printout from a Toshiba Estudio 351C, It do the same in print and Copy. Second transfer roller was changed.
I'm doing some other cleaning procedures, but I think that will be like a standard cleaning. This failure could be another thing.

Any suggestions or comments will be really appreciated.

Thanks to all.

Check transfer belt.

[jcontractor]

I just disassemble all unit minutes ago, First Transfer Roller was in very good condition, I clean up al toner residues and the transfer belt was in a good conditions too. I will let you know as soon I test the machine today.

[jcontractor]

Everything was cleaned, transfer belt was in a good condition, what do you recommend?

[tinnyjay]

Everything was cleaned, transfer belt was in a good condition, what do you recommend?

Still the same?

Is it print or copy?

Try a 05-200 and make user calibration.

[jcontractor]

OK, I'm just in the front of the machine right now.

[tinnyjay]

OK, I'm just in the front of the machine right now.

Still the same?

Is it print or copy?

Try a 05-200 and make user calibration.

[jcontractor]

Both now is worst.

[jcontractor]

I clean the Transfer components and now I have a problem with cleaning blade of the transfer belt, I have color lines in my prints and copies.

[tinnyjay]

Both now is worst.

Did u make a calibration to check printout color blocks?

[tinnyjay]

I clean the Transfer components and now I have a problem with cleaning blade of the transfer belt, I have color lines in my prints and copies.

This is a mechanical problem.

Check the plastic plate of Drum Cleaning Blade mechanism.
Is it straight,or curved.
It can touch transfer belt.
Check it out.

[jcontractor]

OK. I run the color blocks calibrations.
It is getting a little bit more clear.

[tinnyjay]

OK. I run the color blocks calibrations.
It is getting a little bit more clear.

Try 05-200 and wait till it finishes.After that,try calibration.

[jcontractor]

I will change the cleaning blades, I let you know later on the week.