waste toner filling

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • mhmsaqer
    field Supervisor

    50+ Posts
    • Jun 2007
    • 83
    #1

    waste toner filling

    dear all,
    e-450 is continuously filling the waste toner bottle and the toner bottle is stand just for 5000 copies,background is exist.
    new drum,blade,developer
    any suggestions for this.
    -----------------------------
    Be happy for a moment - this moment is your life.
    Omar Khayyam
    -----------------------------
    Tags: adjustmen, allow, ces, dev, down, filling, miles, off, old, over, toner, waste toner, wrong
    • Sundog
      #2
      How old is the drum and developer? Hold down Start and the number 6. When the copier comes up (warmed up) input 103 and start. This will allow you to see all the PM parts, how many miles are on them and PM allowances. Good Luck

        Comment

        • blackcat4866
          Master Of The Obvious

          Site Contributor
          10,000+ Posts
          • Jul 2007
          • 22997
          #3
          I don't know much about Toshibas but this sounds to me like extreme overtoning. When you changed the developer:
          1) was it the right kind?
          2) did you stir it?
          3) did you get acceptable stir readings?
          4) was there any abnormal noise from the developing unit when it was empty (i.e. seizing developer bearings or mag roller)?
          If you'd like a serious answer to your request:
          1) demonstrate that you've read the manual
          2) demonstrate that you made some attempt to fix it.
          3) if you're going to ask about jams include the jam code.
          4) if you're going to ask about an error code include the error code.
          5) You are the person onsite. Only you can make observations.

          blackcat: Master Of The Obvious =^..^=

            Comment

            • Sundog
              #4
              Overtone is easy to see. If you take the developer and drum out there will be toner dusted all over the bottom of the cavity where the developer tank was. This means the developer was changed and the toner density sensor was not set correctly.

              Sounds like you need to clean the cavity and change the developer. Do this after you get new developer in it before you do anything else. Turn it on and hold down the Start key & 6 key, then input 1 and start. Let it agitate for 2 mins. This will set the toner density value. You will have to hit SET on the LCD to keep the setting. Turn off (switch) and back on. You are done.

                Comment

                • etsmultan
                  Trusted Tech
                  • Apr 2007
                  • 131
                  #5
                  I think the developer u used in not properly installed r developer is wrong

                    Comment

                    • tsbservice
                      Field tech

                      Site Contributor
                      5,000+ Posts
                      • May 2007
                      • 7963
                      #6
                      High Voltage adjustment may be?Check dev bias and also if you have a jig other voltages.Good luck.
                      A tree is known by its fruit, a man by his deeds. A good deed is never lost, he who sows courtesy, reaps friendship, and he who plants kindness gathers love.
                      Blessed are they who can laugh at themselves, for they shall never cease to be amused.

                        Comment

                        Previous template Next
                        Working...