replaced system board tried to update hdd and firmware , neither would take . machine is still stuck on splash screen . any ideas on a fix?
toshiba 723 stuck on splash
Collapse
X
-
jfiscaro
Comment
-
Re: toshiba 723 stuck on splash
Did you make sure to put the Nvram & ROMs off the old system board onto the new one?
Is the board new or second hand? if it's not new, is it an older rom version than the one you removed? (had a similar issue on 4511s when fitting a S/H sys board & the rom version on the board was much lower than the one that came off & the MFD wouldn't boot)
Is it the correct sys board (ie: not for another varient of the RIO)?
Have you tried changine the HDD as this is probably the most common cause of an MFD not booting / hanging at the 'splash screen'.
can you get into 05 or 08 mode? if you can, check the serial number is there.
What was the initial fault? fairly unusual for a sys board to fail on these.Happiness Is The Road.Comment
-
Re: toshiba 723 stuck on splash
Try forcing the firmware upgrade with DLM320 jig and latest EPROMS.Comment
Comment