CEC0 - CS 650 aka eS65R4 CEC0 - CS650 aka eS 6550

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • WilliamTucker
    Technician
    • Jul 2012
    • 38

    #1

    [CQ] CEC0 - CS 650 aka eS65R4 CEC0 - CS650 aka eS 6550

    After I had rebuilt the fusing drive section this code appeared. Checked all connections and harnesses specified in the manual as well as test mode. No fried boards.

    Tried the one way gear both directions. No change. I am very confidant my drive system is perfect though.


    Very confusing, my task did not require me to screw with the secondary transfer


    Though I noticed it said at the bottem to check mechanical actuators and sensors etc.
    ....which??
  • michaelc
    Field Tech

    Site Contributor
    500+ Posts
    • Mar 2011
    • 590

    #2
    Re: CEC0 - CS 650 aka eS65R4CEC0 - CS650 aka eS 6550

    Did you check the wire harness you move to one side when you take out the drive. Could also be a different fault completely and may not have anything to do with what you have done.
    It didn't say that I couldn't do it in the manual.

    Comment

    • WilliamTucker
      Technician
      • Jul 2012
      • 38

      #3
      Lol it was actually a bit of the one way gear from the main drive that had broken off jammed up in the secondary transfer motor. Ridiculous!!!

      Comment

      • michaelc
        Field Tech

        Site Contributor
        500+ Posts
        • Mar 2011
        • 590

        #4
        Re: CEC0 - CS 650 aka eS65R4CEC0 - CS650 aka eS 6550

        The joys of the job we do.
        It didn't say that I couldn't do it in the manual.

        Comment

        Working...