Keep getting 077-130 / IOT Exit Sensor already replaced

[alextech]

I keep getting the 077-130 on a Xerox 550 Machine. Printing is just fine unless the Paper turns around like for Duplex.
Had first a bad Acctor inside the Inverter. Cleaned and fixed it, then. After then no more Jams, exept this one.

I have replaced already the Sensor IOT Exit sensor 130K88400, but no Change. Paper goes intro Duplex and stops in the Middle after Sensor.


Any Ideas? Maybe someone knows address to test the Sensor in Diagnostics. Unfortunately, I don't have the service manual for this box

Thanks

Alexander

[xcopytech]

Re: Keep getting 077-130 / IOT Exit Sensor already replaced

77-130 duplex out sensor
Does paper come in duplex?
Check duplex motor and duplex drive belt, one way bearing gears

[adriansto]

Re: Keep getting 077-130 / IOT Exit Sensor already replaced

I keep getting the 077-130 on a Xerox 550 Machine. Printing is just fine unless the Paper turns around like for Duplex.
Had first a bad Acctor inside the Inverter. Cleaned and fixed it, then. After then no more Jams, exept this one.

I have replaced already the Sensor IOT Exit sensor 130K88400, but no Change. Paper goes intro Duplex and stops in the Middle after Sensor.


Any Ideas? Maybe someone knows address to test the Sensor in Diagnostics. Unfortunately, I don't have the service manual for this box

Thanks

Alexander

Read this post to the end:
Xerox Color C60 - Error 077-118

[alextech]

Re: Keep getting 077-130 / IOT Exit Sensor already replaced

Read this post to the end:
Xerox Color C60 - Error 077-118

Okey. Disamble the whole thing and clean :-(

I will give feedback when done

Thx.