Docucolor 12 Power Save on, No start up

Collapse
X
Collapse
 
  • Page of 1
  • Time
  • Show
Clear All
new posts
Previous template Next
  • jcontractor
    Trusted Tech

    Site Contributor
    100+ Posts
    • Aug 2010
    • 247
    #1

    [Dead] Docucolor 12 Power Save on, No start up

    Hi,

    First, thanks to everybody for all the help in all posted failures in this forum.

    I have a DC 12 with power save green light on and no warming up.
    This is my first failure of this kind, I follow the Troubleshooting procedure (Power Save Green Ligth RAP) in the service manual.
    Also I follow 5+VDC RAP, because 5V wasn't present.

    And finally: no 5.1 V, No 5 V, No 12V present at LVPS Board.
    It have 110VAC at PCB input, Main LVPS fuse is good.
    No other check of the PCB was performed.

    As you experience, if I change the LVPS my problem will be solved?
    Or is any other troubleshooting to be performed before proceed to change this PCB?

    Any comment will be really appreciated.
    Tags: dc 12, docucolor, docucolor 12, light, low voltage, lvps, power save, service manual, warming up
    • JimmyB
      Technician

      50+ Posts
      • Jun 2008
      • 77
      #2

        Comment

        • jcontractor
          Trusted Tech

          Site Contributor
          100+ Posts
          • Aug 2010
          • 247
          #3
          Re: Docucolor 12 Power Save on, No start up

          Yes, that's the pcb that doesn't have output voltage in my machine.
          Thanks a lot for your comment.
          Really appteciated.

            Comment

            • S ali
              #4
              Re: Docucolor 12 Power Save on, No start up

              I have same problem where can we get this pcb should we buy from xerox or its available in electronics shops.

                Comment

                Previous template Next
                Working...