Brother DCP 8060 replace PF Kit came up, did that then turned power off and unplugged to reset, but replace PF Kit still appears.
-
-
Press 88, display reads "Parts Replacement"
^/v to "Reset PF Kit T1"
OK or Start
Stop to exit. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Maintenance Mode
Thank you for the info but I am unable to find instructions for getting into maintenance mode on this machine. Could you please list the complete steps.
Thanks so much.Comment
-
Are you having trouble finding it in your service manual? Its on pg 295.
It looks like this:
maintenance mode&#46.JPGIf you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Thanks so much but this machine is a DCP8060 and these instructions don't seem to apply.Comment
Comment