Re: Designjet 500. x over ink ctg but no error
Ok. Make sure the wide grey ribbon cable that connects the EMOD to the interconnect board (that the front panel, service station, ISS, etc connect to) is free and not pinched behind the right support, that's the only other thing I can think of that might cause a ISS issue. Baring that, I'd try another EMOD.
Maybe try disconnecting the trailing cable from the EMOD, see if anything changes. You should get an 11:11 error. I've never had a bad trailing cable or carriage cause the flashing X business.
Kiran
Ok. Make sure the wide grey ribbon cable that connects the EMOD to the interconnect board (that the front panel, service station, ISS, etc connect to) is free and not pinched behind the right support, that's the only other thing I can think of that might cause a ISS issue. Baring that, I'd try another EMOD.
Maybe try disconnecting the trailing cable from the EMOD, see if anything changes. You should get an 11:11 error. I've never had a bad trailing cable or carriage cause the flashing X business.
Kiran
Comment