HP DJ T795

[CP-1015]

Re: HP DJ T795

Sorry for my late reply - but my colleague has picked up his plotter and is only providing information sporadically.

In the end there was only an error message from the formatter! Is there something to watch out for when / after replacing the formatter battery. It was less than 3 volts.

[Kiran Otter]

Re: HP DJ T795

I'm not sure I understand. Replacing the battery fixed the 08:04 error? That would be surprising if so.

The hard drive is the weakest link on the formatter.

Kiran

[CP-1015]

Re: HP DJ T795

I'm not sure I understand. Replacing the battery fixed the 08:04 error? That would be surprising if so.

The hard drive is the weakest link on the formatter.

Kiran

I don't think the battery fixed 08:04, too. But I'll ask him about the last error code and write it here. Until then, thanks you.

[Phil B.]

Re: HP DJ T795

I'm not sure I understand. Replacing the battery fixed the 08:04 error? That would be surprising if so.

The hard drive is the weakest link on the formatter.

Kiran

+1 on HDD being weakest link.

Sent from my SM-G960U using Tapatalk

[CP-1015]

Re: HP DJ T795

According to my colleague, the plotter works flawlessly. When asked again about the cause, he did not answer. I can only speculate whether an error was actually displayed after changing the printhead. Thank you very much for your help!