This was brought into my shop completely in pieces. I have never had the opportunity to take these apart before, so I had to figure it out as I went. When I first started it, it printed the image and stopped part way though the output. I got that sorted out. Then I tested again, and it was coming out blank and the solenoid just kept firing rapidly. I cleaned off the sticky pad and replaced it. It still does the same thing. If solenoids are known to start firing on their own, I will replace it. I'm concerned if it may be something deeper into the machine and what would cause it. I'm not concerned about advice or opinions on the age of the machine.
Thank you for your thoughts and consideration.
Thank you for your thoughts and consideration.
Comment