[Error Code] 50.7 FUSER ERROR

[myli]

Hello

There CP4525 device. Fuser and fuser drive assy . Despite the change of error 50.7 fuser error. Cables were checked. Reason you think.

was the so-called service manual. But the problem being solved. Do you Have a different solution?

Thanks

[prntrfxr]

Re: 50.7 FUSER ERROR

Service manual says:
1.) Reconnect the fuser-pressure releasesensor intermediate connector J60, and
connector J128 on the DC controller
PCA

2.) Run the sensor test in the sensor
monitor mode to verify that the fuser
pressure-release sensor is functioning
properly. If it is not, replace the fuser
pressure-release sensor.

3.) Check the fuser pressure-release
sensor flag. If it is damaged, replace the
fuser.

4.) Run the fuser pressure-release drive
test in actuator drive mode to verify that
the fuser motor is functioning properly.
If it is not, replace the fuser motor. See
Fuser motor on page 200.

5.) If the message persists, replace the
fuser. See Fuser on page 85.

I assume you have tried every one of these steps. What were the results of the sensor test and the fuser pressure-release drive test? Did you replace the pressure release sensor? Did you replace the fuser motor? When you have tried everything else the DC controller would probably be the next step. Please reply with the resolution to the problem when you find the fix.