Hp 4345 skew from tray 3

[mrfuser]

Tray 1 & 2 are fine, skews only from tray three. Swapped out new feed rollers and cleaned path. No good still.

any ideas?


kelly

[prntrfxr]

Re: Hp 4345 skew from tray 3

Torque limiter (clutch in the tray) issue?

[ucinn]

Re: Hp 4345 skew from tray 3

Tray 1 & 2 are fine, skews only from tray three. Swapped out new feed rollers and cleaned path. No good still.

any ideas?


kelly

Bent tray perhaps? Did you try swapping the trays to see if the problem moved with the tray?

[CRam007]

Re: Hp 4345 skew from tray 3

Do you have any specific error code on the control panel? as Ucinn said many times is a tray issue, and when you said just with the 3 tray means tray 2 and 1 works normal with no problems printing a heavy amount of prints?

let us know more details

Regards

[mrfuser]

Re: Hp 4345 skew from tray 3

Yes only tray 3 skews , no error as it spits it out fine just skewed image

[CRam007]

Re: Hp 4345 skew from tray 3

Ok, what happens when you change the tray position? (tray 2-3) and also i would recommend you check if the paper came in the right way from this tray also make sure the guides paper on the tray aren't to tight and properly seat.

[mrfuser]

Re: Hp 4345 skew from tray 3

It is not the tray I switched first. Did all else you mentioned.
This ain't my first rodeo on these guys.

If it were easy we would all be doing it! Lol

Ok, what happens when you change the tray position? (tray 2-3) and also i would recommend you check if the paper came in the right way from this tray also make sure the guides paper on the tray aren't to tight and properly seat.

[Iowatech]

Re: Hp 4345 skew from tray 3

This might not help a lot (and if so, sorry about that), still, have you checked out the operation of the paper feed solenoids for drawer 3? Specifically whether they get hung up on the noise reducing rubber pads?

[CRam007]

Re: Hp 4345 skew from tray 3

Ok Genius,

then you should discard with another entire good know tray 3 seems as prntrfxr said a tray's clutch issue.