XN-5163 Maintenance counter reset

[copydocinc]

I reset the adf rollers maintenance kit counter and the feed roller count, but I cant find where to reset the main Maintenance counter.
Help please It's XM-5163 not XN sorry

[dalewb74]

Re: XN-5163 Maintenance counter reset

you should call a lexmark tech. to your location. simple fix.

[copydocinc]

Re: XN-5163 Maintenance counter reset

you should call a lexmark tech. to your location. simple fix.

Not asking for this kind of advice.
Asking for the reset sequence
If you care to notice, I've been here a while
and probably repairing printers longer than most
I just don't have all the answers myself
If you have the answer, then by all means, let loose with it.
pretty please
Is begging what you want

[Woxner]

Re: XN-5163 Maintenance counter reset

you have to replace (install maint kit) this auto resets. its not like the older machines where you reset in the 26 mode.

[poultryman17]

Re: XN-5163 Maintenance counter reset

There is also a MS810CRUM chip you can replace on the fuser itself (sits under black casing facing you when you remove from the machine) that will reset the maintenance count. Not sure where my company gets them but if the fuser is in descent shape the chip saves quite a bit of money

[greglogston]

Re: XN-5163 Maintenance counter reset

I reset the adf rollers maintenance kit counter and the feed roller count, but I cant find where to reset the main Maintenance counter.
Help please It's XM-5163 not XN sorry

Update firmware and in status notifications can you set end of life off?

[mloudy]

Re: XN-5163 Maintenance counter reset

There is also a MS810CRUM chip you can replace on the fuser itself (sits under black casing facing you when you remove from the machine) that will reset the maintenance count. Not sure where my company gets them but if the fuser is in descent shape the chip saves quite a bit of money

This might be it. Search ebay for "40G4135 Fuser Reset", $24.95. I ordered one to see if it would work and it did.