Thanks Thanks:  0
Dislikes Dislikes:  0
Results 1 to 3 of 3
  1. #1
    Senior Tech 100+ Posts
    Join Date
    Oct 2012
    Location
    Belize
    Posts
    137
    Rep Power
    0

    IRA4225 Error code E000014-002 displayed

    I have replaced the fuser film, presssure roller and bearings and error occurs occasionally. I have tested fuser motor and it works properly. Any advice and next step.
    Thanks

  2. #2
    Service Manager 10,000+ Posts
    IRA4225 Error code E000014-002 displayed

    teckat's Avatar
    Join Date
    Jan 2010
    Location
    VA
    Posts
    16,023
    Rep Power
    234

    Re: IRA4225 Error code E000014-002 displayed

    Quote Originally Posted by ldfrepairs View Post
    I have replaced the fuser film, presssure roller and bearings and error occurs occasionally. I have tested fuser motor and it works properly. Any advice and next step.
    Thanks

    COPIER>FUNCTION>FIXING
    NIP-CHK Check of fixing nip width.

    Use case - When replacing the fixing-related parts (fixing Roller, Pressure Roller)
    - When a fixing failure occurs
    Adj/set/operate method
    1) Print approx. 20 sheets of A4 size paper.
    2) Make a solid black print (setting value: 7) with COPIER> TEST>PG> TYPE.
    3) Set the output of step 2 on the Multi-purpose Tray while placing the printed side down.4) Perform the size setting of the Multipurpose
    Tray.
    5) Select the item, and then press OK key.A sheet is stopped once in a state held by the Fixing Nip area, and is delivered
    approx. 20 seconds later.
    6) Measure the nip width of delivered sheet.

    It is judged as normal: (iR-ADV 4251: 8.1 to 10.1 mm, iR-ADV 4245/4235/4225 :7.5 to 9.5 mm) at the center, and difference
    between front and rear is within 1.0 mm. If there is an error, execute step 6.

    7) Check the Fixing Roller, Pressure Roller, and Fixing Lower Unit,
    and replace damaged part.
    Related service mode COPIER> TEST> PG> TYPE



    did u have a CQ issue before code

    >try this --remove drum n' dev unit and inspect the HV connections > now re-seat drum and dev unit.



    1. Check connection of the Connector (J2001/J203).
    2. Replace the Fixing Motor (M2).
    3. Replace the DC Controller PCB (UN2).

    how stable is your Supply Voltage from outlet
    especially Neutral to Ground - should be 0v +/- 0.5v at all times
    **Knowledge is time consuming, exhausting and costly for a trained Tech.**

  3. #3
    Senior Tech 100+ Posts
    Join Date
    Oct 2012
    Location
    Belize
    Posts
    137
    Rep Power
    0

    Re: IRA4225 Error code E000014-002 displayed

    Thanks will perform nip width test

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
Get the Android App
click or scan for the Copytechnet Mobile App

-= -= -= -= -=


IDrive Remote Backup

Lunarpages Internet Solutions

Advertise on Copytechnet

Your Link Here