i have a ir2880 that does not produce cyan on pronts and copys...i have hoovered out toner supply and it works for approx 1 week then bounces out again...any ideas thanks
-
-
We've had 2880's do this...mostly on yellow and black...but each time it was the drum unit.Comment
-
1) Replacing the Develop Sleeve Clutch "CL2" (FM2-3581-000) in the field has resolved the issue.
2) In this case the replacement of the sub PDRM-EF-A pcb resolved the issue. It was determined that it was the cause by following the steps below:
1. Re-fit 2 main controller sub PDRM-EF-A PCBs
2. If the symptom still occurs, interchange the upper and lower main controller sub PDRM-EF-A PCBs .
3. If the combination of colors that causes the symptom changed from yellow and black to cyan and magenta, suspect a faulty main controller sub PDRM-EF-A PCB and replace the PCB with a new one.
4. If the symptom does not change after Step2, replace the main controller PCB (main) with a new one.
FM2-9163 Main Controller PCB Assembly
FM2-9166 PDRM-EF-A PCB Assembly (S)
These are two cases in the field. Maybe this helps.Comment
-
thx for help....parts on order will let you know how i get on...Comment
-
There is a problem with these machines on the toner shutters not opening correcly when you engage the process unit handle.....new modified rack. Machine should be giving you E-020 errors if a color is missingComment
-
thx 4 help...clutch fitted...no probs so farComment
-
The clutch fixed it?
Here are notes from the user guide regarding colors that might not be pick up WHEN USING THE FEEDER!
To remedy this problem here is a suggestion:
Service Mode>Level 2
Copier>Adjust>Misc>ACS-EN2 Set to +2 [Default is +1]
Copier>Adjust>Misc>ACS-CNT2 Set to +2 [Default is 0]Comment
Comment