IR5570 "Original may not be scanned clearly........ Clean scanning glass."

[bartman]

This message appears often when copying or scanning. The scanning glass is not dirty or worn. Have cleaned scanning glass, optics and document feeder rollers above scanning glass. Thx

[JPP Océ]

you need to go on the service machine and adjust the sensibilite of the sensor ... the sensor take a reference test still if you clean its not that like i said you need to chance the value

[charm5496]

copier>option>body>DFDST-L1 and L2. Change them both to a 1

[JPP Océ]

copier>option>body>DFDST-L1 and L2. Change them both to a 1

thats it

[bartman]

I changed the DFDST-L1, L2 to 1 like you suggested and it seems to have worked. Thank you very much.

[JPP Océ]

[mrfixit51]

Also, to get away from the annoying "Clean slit glass" warnings, you can go into Additional Functions>Copy Settings> 6th 0r 7th page and turn off the dirty slit glass notification...

[charm5496]

I changed the DFDST-L1, L2 to 1 like you suggested and it seems to have worked. Thank you very much.

you are welcome!

[Canuck]

Also in service mode...COPIER>OPTION>BODY...set DF-BLINE to 1 then reboot. This will disable edge emphasis when using doc feeder and reduce chances of lines when glass is dirty.