Canon IR105+ Paper Misfeed

[tinnyjay]

Hello
My IR105+ has paper misfeeding in the entrance of fuser and rare on the transfer.
Fuser motor is working good and fuser is serviced,new rollers,thermistors,gears,barings.
The clutch on transfer separation corona i think is working,because i see the gears rotating.
Can you help me?

[teckat]

And the Jam code is ~~~~~~~~~~CoolClips_cart0753.jpg

[tinnyjay]

And the Jam code is ~~~~~~~~~~[ATTACH=CONFIG]8550[/ATTACH]

Sorry Teckat
I have to see it tomorrow.

[CT Copier Repair]

is the paper making it into the fuser? If so then its the fuser entrance sensor. Or if not start looking at the transport unit

[davidj7]

i have seen paper hitting on the fuser entrance paper guide . problem was transport unit

[tinnyjay]

is the paper making it into the fuser? If so then its the fuser entrance sensor. Or if not start looking at the transport unit

I have to check it today and i think paper hit the fuser and stops there,maybe for inertia of transfer.
Appreciate your help

[mrfixit51]

Rewire or replace the transfer/separate corona may help. Poor separation can cause the lead edge of the copies to adhere to drum, hit the sep claws and turn over on the transport...