hello i its a canon irc5185i , when i run the print it it freezes then restarts , but when i copying its ok
-
-
Re: the printer first restarts when I start printing
How long is this "freeze"?
When you send a print job, the first thing the MFP does is start warming up the engine. If the print data has completely arrived by the time the engine is warmed up, it prints immediately. If the machine is still receiving print data when warmup is complete the engine will remain warmed up, but turn off motors in anticipation of receiving the first complete page of print data. In essence, this sounds to me like you've got a slow network connection.
=^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: the printer first restarts when I start printing
Please attach a sample.
Are you using the exact correct Canon print driver for your OS? =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: the printer first restarts when I start printing
img104.jpgimg103.jpg
Here are two samples before and now in PS modeComment
-
Re: the printer first restarts when I start printing
---------------------------------------------------------
Remove> clean ends & reseat all the PCB's on the main controller
sometimes u get various errors & sometimes u get a digital mess (as shown on t print)
pdf lists error issues/ but I have seen sub boards cause Print Issues
see pdf-----
Board Cleaning_Board Position-TP07 094.pdf
PCB LOCATIONS_2.JPG
PCB LOCATIONS_.JPG
Last edited by teckat; 03-07-2014, 06:22 PM.**Knowledge is time consuming, exhausting and costly for a trained Tech.**
Comment
-
Re: the printer first restarts when I start printing
hello i tried to clear all of composants ,, exept SRAM circuit board but the trube rest the same , when i run the print job ;i have more than 5000 works,,,, some of theme notified NG 852,, i tried to clean all of these jobs ; but no way ;; i tried to renitialise the HDD , MN CON clear , mmi ..... but the prints job steel here ,, should i disconnect SRAM circuit board and re seat ????---------------------------------------------------------
Remove> clean ends & reseat all the PCB's on the main controller
sometimes u get various errors & sometimes u get a digital mess (as shown on t print)
pdf lists error issues/ but I have seen sub boards cause Print Issues
see pdf-----[ATTACH]24289[/ATTACH]
[ATTACH=CONFIG]24291[/ATTACH]
[ATTACH=CONFIG]24290[/ATTACH]
Comment
-
Re: the printer first restarts when I start printing
Never seen a printer with 5000 prints stored in it.
Call for a trained tech to inspect.**Knowledge is time consuming, exhausting and costly for a trained Tech.**Comment
-
Re: the printer first restarts when I start printing
Good luck.....don't understand you. Place a service callComment
Comment