Have recently noticed that these models look exactly the same .is the kip 7170 same rebranded kyocera 4820w
-
failure is not an option ! -
Re: Is kip 7170 same as kyocera 4820w
Trouble code E801...not in manual
Sent from my SM-N920V using Tapatalk -
Re: Is kip 7170 same as kyocera 4820w
"Failure is not an option!"
Its a choice.WhateverComment
-
Re: Is kip 7170 same as kyocera 4820w
Sorry E0801...toner density....not y...it came up
Sent from my SM-N920V using TapatalkComment
-
Re: Is kip 7170 same as kyocera 4820w
Nope. E081 is toner density.
I'm thinking that E801 is something to do with memory capacity. When my enduser sends 54 pages at ~1/2M each, it locks up during the first page and must be shut down to clear. The corrupt job remains in the queue until it is deleted. If my enduser sends 35 pages or less it does not occur. Maybe there's a limit to how many pages that the queue will hold?
Does anybody have a definition of this code? It doesn't appear in my manual. The only reference I can find is "Other Service Codes not listed in the manual", and refers to three bulletins that I don't have. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: Is kip 7170 same as kyocera 4820w
do you think it could be e801 transfer chrargeComment
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: Is kip 7170 same as kyocera 4820w
this is a toner density error
Wires: 1 Is the wire between Toner Density
Sensor and PW13420 PCB connected
properly?
No Connect it properly.
Density Sensor
(PH11)
2: Can you fix the problem if you replace
Density Sensor?
No Replace PW13420 with a new oneComment
Comment