Bizhub 600

[Syed Naseem]

Hello everyone..
I have a bizhub 600 which show paper jamming J-3206.
I will check completely but nothing paper anywhere.
I replace complete ADU unit but still issue same.
Have any friend idea how to resolve this issue.

[Synthohol]

Re: Bizhub 600

its the exit sensor turning on during idle.
not an ADU issue.

[Syed Naseem]

Re: Bizhub 600

its the exit sensor turning on during idle.
not an ADU issue.

I replace the exit sensor too..
But problem still same.

[Woxner]

Re: Bizhub 600

take the left end cover off and remove the exit assembly. paper maybe stuck in there and the mylar could be bent . could also be adu pwb

[Synthohol]

Re: Bizhub 600

yeah, give that actuator an extra spring wrap if you can.
sensor check 24-2 is the exit sensor PS37

1. "Service Mode screen" Press the [State Confirmation] key.

2. "State Confirmation screen" Press the [Sensor Check] key.

3. "Sensor Check screen" Enter the check code and the multi code with the sheet number setting button. The condition (H/L) of the sensor appears.

4. When conducting other sensor checks, repeat Step 3.

5. Press the [OK] key. State Confirmation screen appears.

[Syed Naseem]

Re: Bizhub 600

yeah, give that actuator an extra spring wrap if you can.
sensor check 24-2 is the exit sensor PS37

1. "Service Mode screen" Press the [State Confirmation] key.

2. "State Confirmation screen" Press the [Sensor Check] key.

3. "Sensor Check screen" Enter the check code and the multi code with the sheet number setting button. The condition (H/L) of the sensor appears.

4. When conducting other sensor checks, repeat Step 3.

5. Press the [OK] key. State Confirmation screen appears.

I replace exit unit too...
Still same situation......

[Synthohol]

Re: Bizhub 600

i'd try to reflash firmware then
trace the exit wire back to the prcb and check for a pinched or chafed wire along the way.