Copier is skewing when making copies from the Document feeder and glass, but internal prints are not skewed
-
-
Re: C554 skewing
Just adjust the ADF on the right side hinge . There will be a adjustable screws .
Sent from my XT1562 using Tapatalk -
Re: C554 skewing
I can see that if it was an ADF skew only but if I lay it on the glass I also get skew from all paper traysComment
-
Re: C554 skewing
Most likely the scanner frame had been bent by leaning on the corner. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: C554 skewing
Grab the front left corner of scanner and give it a few upward jerks. Otherwise adj scanner position wgere it sits on wire. Youll only want to move it like 1mm or so.
I try to see if it swuare by lining it up to a straight edge on the frame.
I find its normaly when there is a shelf above copier. They lean on copier of rest boxes on adf but have had a few at runup too so yeahComment
-
Re: C554 skewing
Pulling up on the scanner did the trick, ThanksComment
Comment