If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hehe fun don't order the wrong side(hand) cables...
If it looks bent replace the part.
Make sure the torqueamgiy still works ok to dampen the speed the tray drops at.
Those are still easy.
Messed up a 360 scanner setup.
Was not able to do it with two hands, needed help.
Got some mighty rats around there?
This is where i phone Joe to ask if he has an ex-lease machines somewhere.
Paper loaded at the wrong end of the tray? Or paper loaded under the lift plate? I've seen both resulting in the slow motion, whirr whirr whirr ... (slower) whirr, whirr ... (slower) whirr ... snap, BOOM!
"I just filled the paper. That's all I did." =^..^=
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
its been fixed for a while, i just ran into the pic and i wanted to share the 'cringe' moment with my CTN peers
was like 30 parts, everything was bent to bahjeebers on both sides.
it was kinda therapeutic though.
im in my 19th year in this biz, still diggin the challenges.
whats wrong with me?
We know a thing or two because we've seen a thing or two.
The medication helps though...
Comment