Konica Minolta bizhub press C 1070
Error C 2451 after we replace the developing unit and developer. The problem still occurs we do the toner revert multiple times but code still occurred can you help us in this problem thank you very much
-
-
Re: Konica Minolta bizhub press C 1070
Did you do the Toner Density Sensor Init., in the service mode, under drum peculiarity, first? Also, make sure the charger corona for the Y developer unit is installed fully, and not broken or damaged/ saturated with toner. -
Re: Konica Minolta bizhub press C 1070
Make sure that the primary transfer belt is properly tensioned. I've had one of the cables break that keep the belt tensioned. The belt tracks off center, and incorrectly reads the yellow density patch. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
Comment