Anybody have a source for these feed rollers for this lower unit?? Other than China?
-
-
If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: Kyocera PF 730 feed rollers
They are Part # 2K906010, Set of 3, the 6230,6080,6350,6360,6370, don't work, hair different.Comment
-
Re: Kyocera PF 730 feed rollers
Are you saying the rubber diameter is different or just the hub?Comment
-
Re: Kyocera PF 730 feed rollers
I think I'd make a visual comparison to the Konica Minolta neoprene rollers. I would be surprised if they didn't fit. You might have to press the rubber onto the old hubs. [1] A5C1 5622 00, [2] A00J 5636 00If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Re: Kyocera PF 730 feed rollers
Ordered from E Bay, 20 bucks for 2 sets(China), should get sometime in next 2 weeks, Thanks for the response guys. Will let you know how they work out.Comment
-
Re: Kyocera PF 730 feed rollers
What we're saying is that it's common practice to swap rollers (bare rubber) onto different hubs.Comment
-
Re: Kyocera PF 730 feed rollers
Have done that in the past, thanks for the reminder though,
Also thought about streachies, but thinking might throw timing off. Might have to experiment. Thanks for all the replies. have a good weekend!
Comment
Comment