JAm code 9011 and 9005. It looks like it tries to pull the paper but it doesn't . No obstacle.
Any idea?
Any idea?
-
-
Re: TAskafa 5501 , paper jam at ADF
Did you looked up jam 9011? =^..^=Last edited by blackcat4866; 05-26-2022, 01:52 AM.If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Re: TAskafa 5501 , paper jam at ADF
Clutches and sensors are really solid on this adf. Have you tried cleaning or replacing rollers/belt?Comment
-
Re: TAskafa 5501 , paper jam at ADF
so it's hard to help you, what tests have you done? from memory, for example, the rear pin of the document lifting plate may be brokenComment
-
Re: TAskafa 5501 , paper jam at ADF
Possible sep arbor issue?Comment
-
Re: TAskafa 5501 , paper jam at ADF
What model ADF? I've had problems with the one-way bearing in the gear pack. If you put a little pressure on the roller with your finger, it will stop turning. A sure sign that the bearing is slipping. Good luck.Adversity temporarily visits a strong man but stays with the weak for a lifetime.Comment
-
Re: TAskafa 5501 , paper jam at ADF
The simplest ones for hesi pulls are like what was mentioned dirty/slipping pickup rollers ( the turtle shell looking ones) on the upper or the belt. If not those 2 then the 3rd option for hesitation is checking the torque limiter for a crack in it. Its under the black plate(2 screws) inside the yellow/green/grey whichever color sep roller your using. It just slides right in. They break all the time.Comment
Comment