If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
[CQ]
How to adjust the development bias on TA 3010
Hello, I have a Taskalpha 3010i that the Bias is of (Slight black glow behind letters). There is no auto adjust on SIM 140 and they provide no instruction in the manual on the selections that are in SIM 140. Any help is very appreciated THANKS !!!
DescriptionThe toner sensor control bias is adjusted so that the sensor output is set as the target value withthe initial developer.PurposeAutomatically executed when the developer unit loaded with the initial developer is replaced. Sim. 130
DescriptionThe toner sensor control bias is adjusted so that the sensor output is set as the target value withthe initial developer.PurposeAutomatically executed when the developer unit loaded with the initial developer is replaced. Sim. 130
Comment