Has anyone seen this, I have a TASKalf 520i that wil run 30 to 50 copies than you get a C-2000 code Drive motor failure. I'm at a lost this copier is only two months old with about 128,000 copies on it!
-
-
I'm still having problems with this copier, swap out main motor, PWB board, checked wirring, what else power supply!!! -
Haven't seen it on the taskalfa, but I have seen this code come up repetitively on the FS-9530. We replaced the drum unit and never saw the code again. I would check your motor drive assembly to make sure there are no missing teeth in there, and nothing is binding up, if you haven't already.I must have a prodigious quantity of mind; it takes me as much as a week sometimes to make it up - Mark TwainComment
-
Sorry, I can't help. That's one code that I haven't seen. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
try checking the left hand door interlock switch i think its the same as a falcon1 and 2 and if the actuator doesnt quite hit the microswitch you will get that code. good luckComment
-
This Parts & Service manual can now be purchased for $12.77 and downloaded immediately after payment from
Just Manuals | The Internet's largest selection of manuals | Instant Downloads
Paul@justmanuals.comComment
-
Re: C-2000 Kyocera Taskalf 520i
This copier has benn shut down since end of May, its in a School so I suspect we still have this issue to deal with!Comment
-
Re: C-2000 Kyocera Taskalf 520i
I had one with same issue, was the drum unit starting to seize, replaced drum unit and fixedIBM, Mita, Konica Minolta, Ricoh, Kyocera, HyPAS, Canon, Oce, Samsung, HP, TEO IP PBX/Unified Communications, Comptia Network+ Comptia PDI+ CertificationsComment
Comment