IM C400F

[SCOTTSMILEY]

I have a doc feeder bending both corners but not jamming... Any ideas??????

[luca72]

I have a doc feeder bending both corners but not jamming... Any ideas??????

usual problem of those RDF of shit, open the back cover, tighten the hinge screws, and put some epoxy resin over the screws, wait for it to dry
if you're lucky the plastic hasn't stripped
p.s. exist a ricoh repair kit but cost over 50 euro for 2 piece of metal and two screw...crazy!

[SCOTTSMILEY]

THANKS

[luca72]

THANKS

Check First if the plastic hasnt not stripped, you only could Need replace It with the screws a Little more large in this case...not too, because you could brake the plastic

[copier tech]

I have a doc feeder bending both corners but not jamming... Any ideas??????

See attached bulletin, this works well.


ADF Hinge Break.pdf

[jumpinj18]

I filled holes with JB weld and it seems to be working fine. Hinges really do suck.

[luca72]

I filled holes with JB weld and it seems to be working fine. Hinges really do suck.

and think that even now, they are still like this!
a bit it is also the client who lifts it too violently, it seems like they do gymnastics with the rdf....lol

[SCOTTSMILEY]

100% RIGHT... THANKS AGAIN