Looking for words of wisdom on cause. MP 9300 lite,grey copies, prints. Before I touched it has a history of same from previous techs. I replaced developer no luck. Unable to set td sensor. Click on this for details
MP 9003 lite copies
Collapse
X
-
Tags: None
-
If it was just copying I would say dirty optics. Since it is printing also, most likely a dirty or bad ID sensor. If by TD sensor you actually mean the ID sensor, SP 3001, then a dirty sensor will cause a reading considerably greater than 70. The dirtier the sensor, the higher the reading. The higher the reading, the lighter the print. If there is a lot of toner on the PCU frame the sensor is mounted on you may need to replace the cleaning brush. I have also seen the opening through the front of the PCU housing clog.👍 2Comment
-
strange, I see that the "check" sign at the bottom is red, and the front door is open"I'll be back"👍 2Comment
Comment