A1035 sc350

[Voltage]

anybody knows the description f the SC350 error code on A1035?
I dont have this explaination in the service manual>

sc 350 is an id sensor error you can check this in sp mode 3103
and it will tell what the values are. Id sesor v should be 4v.It could be as simple as running id sensor voltage adjustment sp 3001-02 which automatically adjust id volt. Your problem could be a dirty id sensor however unlikely Drum cleaning problem would give poor id sensor voltage. cleaning dev roller and changing developer and drum would fix your problem.

Good luck

[Ricoh-ono]

u have to reset the copier and after entering service mode enter 5801#then execute memory then on/off it will ok,otherwise it may be u hv to replace developer

I have never had to do a memory clear (sp-5801) in order to correct a SC-350 error code. A memory clear should be one of the last things to try.

[etsmultan]

u have to reset the copier and after entering service mode enter 5801#then execute memory then on/off it will ok,otherwise it may be u hv to replace developer

[djq2]

sc 350 relates to
the I.D. sensor.. possibly dirty needs to be cleaned and initialized... or the developer needs replacement due to low density pattern on the drum,
hope ths help's

[petrus]

anybody knows the description f the SC350 error code on A1035?
I dont have this explaination in the service manual>