MX-3070-4070-5070-6070N

[Alpanapa]

Re: MX-3070-4070-5070-6070N

or maybe this will help

See attached bulletin

[SpYdAsWeB]

Re: MX-3070-4070-5070-6070N

Hi chaps,

there is now an official modification for this. See the new bulletin attached...

or maybe this will help

See attached bulletin

[Toner Boy]

Re: MX-3070-4070-5070-6070N

Hard to believe we're having to deal with this again, had same issue with 3501's and dummy punch mylar way back when. Total dejavu

[branjake]

Re: MX-3070-4070-5070-6070N

We have been having multiple problems with these finishers, still waiting on a fix.

[1090tech]

Re: MX-3070-4070-5070-6070N

We had this problem with a 3070 and it turned out to be the customers choice of paper. They used bargain bin paper from that came out of the fuser with excessive curl and jammed where the customer could not reach it. We got them to use higher quality paper and the the machine stopped jamming.

[superssport]

Re: MX-3070-4070-5070-6070N

Went out to one yesterday to help a tech. Was said to constant jamming for months . It would jam right at the entry of the finisher. I looked up at the photo sensor at the entry of the finisher and it look foggy. Cleaned sensor and now it's jam free. Tech called later that afternoon and still no jams.

[boutn]

Re: MX-3070-4070-5070-6070N

I had a machine with internal finisher which sometimes gave POD2_S.

Turned out the plastic inlet guide of the punchunit was uneven. Production error i guess.

I had to disassemble it and with a bit of fine sandpaper make it smooth again...

No more jams after that.

[jp74msj55]

Re: MX-3070-4070-5070-6070N

Hi
I hade the same problem with internal finisher it was jamming on FNPS1_S .check out the bulletin, i changed the spring in finisher and it worked for me.

//Jerry
Sweden

The old inner finishers didn't have the mylar strips that are included in the new ones. Tech pub about adding the mylar strips
to prevent jams. Have had many of these that needed the mylar strips installed on the inner finisher.