How to disable auto-cropping scan on a BP-70C45?

[ihatefinishers13]

You are then proving the default scan isn't actually full size on the 70C series, as the corners are cropped.

Apologies, I should have included a photo of the original, so you can compare.

[ihatefinishers13]

Here's something from an old 5070v, just throwing it in there so you can see as well. I can't tell if there is a problem, I'm just putting more samples out there for others to also deliberate on.

[PacMusee]

Apologies, I should have included a photo of the original, so you can compare.

No, it's ok. It was clear you use my same template for corners, and it showed as cropped.

[ihatefinishers13]

No, it's ok. It was clear you use my same template for corners, and it showed as cropped.

But what about the 5070v sample? It shows cropping as well, but different sides. Idk what to make of it

[PacMusee]

Here's something from an old 5070v, just throwing it in there so you can see as well. I can't tell if there is a problem, I'm just putting more samples out there for others to also deliberate on.

Thanks.
Weirdly, the corners near the starting point of the glass are ok, while the exterior corners were cropped... That doesn't go in the same direction of either issue!

[ihatefinishers13]

Thanks.
Weirdly, the corners near the starting point of the glass are ok, while the exterior corners were cropped... That doesn't go in the same direction of either issue!

At this point, every machine is different, every one of them need aligned and such when a dealer gets them... You'd think by now Sharp would have it down to a perfect science.... But they're not getting a lot of things right, lately.

[PacMusee]

Good news!
Calibration was done on every copier here, and the parameters were simply set to 0 to obtain the full scan. No more cropping!