Hi i have a sharp ar276 all up to service but is extracting the developer from the dev unit.its pulling quite a bit through the machine causeing jaming issues.THe copies are perfect no background at all no error codes either.Any ideas would be greatly recived.
-
-
I don't recognize the model number. Is this a UK version of the Leopard? If so, replace the drum, blade, and developer together at the same time. It's the drum that causes the developer to dump. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^= -
Yes, this model exist in UE, sharp arm-236/276.Comment
-
Also, make sure the DV seal isn't curled and that the white pads at the sides of the mag roller aren't worn.Comment
-
Also check the left door for warping. Connections to the transfer roller unit are on the door. Make sure there is good contact when the door is closed and that they are clean.Comment
Comment