AR M277 Fuser

[blackcat4866]

ditto. =^..^=

[patwilf]

thanks for the quick response.....i was thinking the same thing.....just needed some back up.......thanks again

[johnbla]

You don't, unless you want a heap load of grief, it is designed to run 'Dry' in the Thermo-plastic bushings.....

Anything gets in there and the whole Fuser Unit will grind to a halt and that will really annoy the Main Motor and Drive interface gears....

You can wipe the Cleaner pad, UFR & LPR with a little bit of 'silly'oil to help things long

[patwilf]

just trying to figure out if you are supposed to grease the upper heat roller bearings when replacing the roller.....the book doesn't say anything about it......just curious if anyone else is doing so