SHARP AR-M 257 Showing Error code H4-01.
Any idea?
Txs.
Any idea?
Txs.
-
-
Fuser error code you can reset with sim 14. If it comes back then you have some type of issue with the fuser. There are quite a few posts on this error code but for some reason the search funtion is not finding them.
Good luck.
Bil -
check thermostat, thermistor and put sim 14Comment
-
Resolved reseting the error:
# * C * 14 START 1 STARTComment
-
Power events can be the cause of an occasional fuser code. =^..^=If you'd like a serious answer to your request:
1) demonstrate that you've read the manual
2) demonstrate that you made some attempt to fix it.
3) if you're going to ask about jams include the jam code.
4) if you're going to ask about an error code include the error code.
5) You are the person onsite. Only you can make observations.
blackcat: Master Of The Obvious =^..^=Comment
-
Its a fuser error. I agree with blackcat,check the power source first,and enter simulation 14 to reset the error.Comment
Comment