If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
It seems I need to advance the fuser cleaning web at a faster rate due to dirty copies/prints with heavy coverage. Sim 43-32 seems to be the one I need to adjust but the explanation in the manual is too vague. Any tips? Thanks in advance.
I have usually set Job end Comp act Check to value of 0 to allow compulsory operation. I then increase Comp act interval by about 5 and decrease job end comp by 2 or 3 This should enable it to run the web sooner and after the end of less jobs.
Comment